If the door switch fails the dispenser will not turn on.
Maytag french door refrigerator water filter not dispenser problems.
If the door switch fails the dispenser will not turn on.
Click here for more information on how to flush the water system.
If the door switch does not have continuity when activated replace it.
Power unit down by turning off the circuit breaker s or unpluging the product for 5 10 minutes.
Repeat until water begins to flow.
2 you may have bought a cheap aftermarket water filter.
The door switch turns off the ice and water dispenser when the refrigerator door is open.
Was the water system flushed after filter installation or replacement.
Find the most common problems that can cause a maytag refrigerator not to work and the parts instructions to fix them.
Dispense water using the water dispenser and note the amount of water flow.
To determine if the door switch is defective use a multimeter to test it for continuity.
Door parts drawer parts drip bowl drip pan parts duct venting parts fastener parts filter parts fuse.
Flush the system is needed every time the filter is changed or once the refrigerator is installed to the water supply line for the first time.
Use a sturdy container to press and hold the water dispenser pad for 5 seconds then release it for 5 seconds.
The filter is located either in the base grille below the refrigerator compartment door or inside the refrigerator compartment.
The air in the water system may cause dripping at the dispenser that is considered a leak or for the water to dispense slowly.
The door switch turns off the ice and water dispenser when the refrigerator door is open.
Dispense water using the water dispenser and note the.
Dispense water with.
1 if your old refrigerator water filter worked and water flowed from the dispenser normally but after installing a new water filter the water is only a trickle from the dispenser try reinstalling the old filter to see if the cause of the issue is the new filter.
Refrigerator water dispenser not working.
To determine if the door switch is defective use a multimeter to test it for continuity.
Air in the water system may cause dripping at the dispenser or small hollow ice cubes.
If the control panel is still not responding try resetting the refrigerator as instructed below.
Flush the water system flushing the water system forces air from the water line after the refrigerator has been installed or the water filter has been replaced.
If the problem persists schedule service.
If the door switch does not have continuity when activated replace it.
If the refrigerator has a water dispenser check for a problem with the filter by doing the following.
Reset power to the product.
If the refrigerator has a water dispenser check for a problem with the filter by doing the following.