I have a maytag maxima front loader and it is doing exactly what the thread above is saying.
Maytag maxima mhw6000xw2 wont run and door stays locked.
Once the washer door is closed the washer can begin operating.
The door lock led light will blink.
Did you just install.
Run a drain and spin cycle.
Was the washer turned on before being connected to water.
During this period you will be able to hear the pump running.
Nothing else will appear to be happening with the machine during this time.
Unplugging for hours did nothing read more.
Does the drain pump run constantly.
The drum will not spin.
Tried unplugging for half an hour and re read more.
If the door lock is defective the washer door will not latch properly.
You will have to remove the dispenser bezel trim to access the cord to pull it to open the locked door.
After 8 minutes the door will unlock.
If the door will not stay open verify that the washer is level.
Is water hooked up to the washer and turned on.
Maytag washer door or lid won t lock.
Is the door locked and the add a garment light on.
The washer will go into a hold and drain routine for 8 minutes.
Door will not stay open.
Door will not lock.
If not call for service.
Is the door locked and the add a garment light off.
See the first image below.
View and download maytag mhw6000xw2 use care manual online.
The door should unlock after 60 seconds.
My maytag maxima mct frontloading washer s door is locked won t start and the door generally is locked and won t open.
The door is locked the pump is humming and the controls are all blank.
01 door lock motor and switch assembly.
The door lock secures the washer door shut during operation.
Mhw6000xg2 mhw6000xr2 mhw6000 series mhw7000 series.
This is a guide about unlocking the door on a maytag front load washer.
The door should unlock after this is complete.
Mhw6000xw2 washer pdf manual download.
Maytag washer door or lid won t lock.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
On occasion the codes come up e02 f06.
Without a model number i can t give you a specific answer but if you have a maytag mah style front load washer the door can be unlocked by pulling the release cord located in the dispenser area.
